Hyundai i30 (PD): Warning and indicator lights / Turn Signal Indicator Light. Low Beam Indicator Light. High Beam Indicator Light

Hyundai i30 (PD) 2018-2024 Owner's Manual / Convenient features of your vehicle / Instrument cluster / Warning and indicator lights / Turn Signal Indicator Light. Low Beam Indicator Light. High Beam Indicator Light

Turn Signal Indicator Light

Hyundai i30. Light

This indicator light blinks:

• When you operate the turn signals.

If any of the following occur, there may be a malfunction with the turn signal system.

- The turn signal indicator light illuminates but does not blink
- The turn signal indicator light blinks rapidly
- The turn signal indicator light does not illuminate at all

If any of these conditions occur, we recommend that you have your vehicle inspected by a HYUNDAI authorised repairer.

Low Beam Indicator Light

Hyundai i30. Light

This indicator light illuminates:

• When the headlights are on.

High Beam Indicator Light

Hyundai i30. Light

This indicator light illuminates:

  • When the headlamps are on and in the high beam position.
  • When the turn signal lever is pulled into the Flash-to-Pass position.

    AUTO STOP Indicator Light This indicator light illuminates: • When the engine enters the Idle Stop mode of the ISG (Idle Stop and Go) system.

    High Beam Assist (HBA) Indicator Light This warning light illuminates: When the high-beam is on with the light switch in the AUTO light position.

    Other information:

    Hyundai i30 (PD) 2018-2024 Owner's Manual: Jump starting. Jump starting procedure

    Jump starting can be dangerous if done incorrectly. Follow the jump starting procedure in this section to avoid serious injury or damage to your vehicle. If in doubt about how to properly jump start your vehicle, we strongly recommend that you have a service technician or towing service do it for you.

    Hyundai i30 (PD) 2018-2024 Owner's Manual: Front fog lamp

    â–  Type A â–  Type B 1. Loosen the pin-type retainers of the under cover and then remove the undercover. 2. Reach your hand into the back of the front bumper. 3. Disconnect the power connector from the socket. 4. Remove the bulb-socket from the housing by turning the socket counterclockwise until the tabs on the socket align

    Categories

     
    Copyright © 2026 www.hi30.net - 0.0102