Hyundai i30 (PD): Interior lights / Vanity mirror lamp, Puddle lamp

Vanity mirror lamp

Hyundai i30. Vanity mirror lamp, Puddle lamp

Push the switch to turn the light on or off.

• Hyundai i30. Vanity mirror lamp, Puddle lamp: The lamp will turn on if this button is pressed. • Hyundai i30. Vanity mirror lamp, Puddle lamp: The lamp will turn off if this button is pressed.

NOTICE

Always have the switch in the off position when the vanity mirror lamp is not in use. If the sunvisor is closed without the lamp off, it may discharge the battery or damage the sunvisor.

Puddle lamp

Welcome light

Hyundai i30. Vanity mirror lamp, Puddle lamp

When all doors (and tailgate) are closed and locked, the puddle lamp will come on for 15 seconds if the door is unlocked by the smart key or outside door handle button.

Escort light

When the ignition switch is in the OFF position and the driver's door is opened, the puddle lamp will come on for 30 seconds. If the driver's door is closed within the 30 seconds, the puddle lamp will turn off after 15 seconds. If the driver's door is closed and locked, the puddle lamp will turn off immediately.

The Puddle Lamp Escort Light will turn on only the first time the driver's door is opened after the engine is turned off.

    Glove box lamp The glove box lamp comes on when the glove box is opened. NOTICE To prevent unnecessary charging system drain, close the glove box securely after using the glove box.

    Other information:

    Hyundai i30 (PD) 2018-2024 Owner's Manual: Headlamp, static bending lamp, position lamp, turn signal lamp and daytime running light bulb replacement

    Type A Type B (1) Headlamp (High) (2) Headlamp (Low) (3) Turn signal lamp (4) Daytime running light (if equipped) (5) Position lamp (6) Static bending light WARNING Handle halogen bulbs with care. Halogen bulbs contain pressurized gas that will produce flying pieces of glass that could cause injuries if broken.

    Hyundai i30 (PD) 2018-2024 Owner's Manual: Rear fog lamp

    1. Loosen the pin-type retainers and screws of the rear wheel guard and then detach it from the rear bumper. 2. Reach your hand into the back of the rear bumper. 3. Remove the socket from the housing by turning the socket counterclockwise until the tabs on the socket align with the slots of the housing.

    Categories

     
    Copyright © 2025 www.hi30.net - 0.0136