Hyundai i30 (PD): Maintenance / Climate control air filter

Filter inspection

If the vehicle is operated in the severely air-polluted cities or on dusty rough roads for a long period, it should be inspected more frequently and replaced earlier. When you, the owner, replace the climate control air filter, replace it performing the following procedure, and be careful to avoid damaging other components.

Replace the filter according to the Maintenance Schedule.

Filter replacement

Hyundai i30. Climate control air filter

1. With the glove box open, remove the stoppers on both sides.

Hyundai i30. Climate control air filter

2. Remove the support strap (1).

Hyundai i30. Climate control air filter

3. Press and hold the lock (1) on both sides of the cover.

4. Pull out the cover (2).

Hyundai i30. Climate control air filter

5. Replace the climate control air filter.

6. Reassemble in the reverse order of disassembly.

NOTICE

Install a new climate control air filter in the correct direction with the arrow symbol(↓) facing downwards, otherwise, it may be noisy and the effectiveness of the filter may be reduced.

    Filter replacement The air cleaner filter can be cleaned for inspection using compressed air. Do not attempt to wash or to rinse it, as water will damage the filter.

    Blade inspection Contamination of either the windscreen or the wiper blades with foreign matter can reduce the effectiveness of the windscreen wipers.

    Other information:

    Hyundai i30 (PD) 2018-2024 Owner's Manual: In case of an emergency whilst driving

    If the engine stalls whilst driving Reduce your speed gradually, keeping a straight line. Move cautiously off the road to a safe place. Turn on your hazard warning flasher. Try to start the engine again. If your vehicle will not start, we recommend that you contact a HYUNDAI authorised repairer.

    Hyundai i30 (PD) 2018-2024 Owner's Manual: Rear fog lamp

    1. Loosen the pin-type retainers and screws of the rear wheel guard and then detach it from the rear bumper. 2. Reach your hand into the back of the rear bumper. 3. Remove the socket from the housing by turning the socket counterclockwise until the tabs on the socket align with the slots of the housing.

    Categories

     
    Copyright © 2026 www.hi30.net - 0.0107