
The drive mode may be selected according to the driver's preference or road condition.
The system resets to be in the NORMAL mode (except if it is in ECO mode), when the engine is restarted.
Information
If there is a problem with the instrument cluster, the drive mode will be in NORMAL mode and may not change to SPORT mode.
The mode changes, as below, whenever the DRIVE MODE button is pressed.

When NORMAL mode is selected, it is not displayed on the instrument cluster.
ECO mode (if equipped)

When the Drive Mode is set to ECO mode, the engine and transmission control logic are changed to maximise fuel efficiency.
Information
Fuel efficiency depends on the driver's driving habit and road condition.
When ECO mode is activated:
The above situations are normal conditions when ECO mode is activated, to improve fuel efficiency.
Limitation of ECO mode operation:
If the following conditions occur whilst ECO mode is operating, the system operation is limited even though there is no change in ECO indicator.
SPORT mode

SPORT mode manages the driving dynamics by automatically adjusting the steering effort, the engine and transmission control logic for enhanced driving performance.
Information
In SPORT mode, the fuel efficiency may decrease.
The battery sensor is deactivated, when the battery is disconnected from the negative pole for maintenance purpose. In this case, the ISG system is limitedly operated due to the battery sensor deactivation.
[A] : Blind spot area [B] : Closing at high speed The Blind-spot Collision Warning (BCW) system uses radar sensors in the rear bumper to monitor and warn the driver of an approaching vehicle in the driver's blind spot area.
1. After driving approximately 7~10 km (4~6 miles or about 10 min), stop at a safety location. 2. Connect the filling hose (3) of the compressor directly to the tyre valve. 3. Plug the compressor power cord into the vehicle power outlet.
Filter replacement The air cleaner filter can be cleaned for inspection using compressed air. Do not attempt to wash or to rinse it, as water will damage the filter. If soiled, the air cleaner filter must be replaced. 1. Loosen the air cleaner cover attaching clips and open the cover.