
[A] : Blind spot area
[B] : Closing at high speed
The Blind-spot Collision Warning (BCW) system uses radar sensors in the rear bumper to monitor and warn the driver of an approaching vehicle in the driver's blind spot area.
The system monitors the rear area of the vehicle and provides information to the driver with an audible alert and an indicator on the outside rearview mirrors.
(1) BCW : Blind spot area
The BCW range varies relative to vehicle speed. Note that if your vehicle is travelling much faster than the vehicles around you, the warning will not occur.
(2) BCW : Closing at high speed
The BCW-Closing at high speed feature will alert you when a vehicle is approaching in an adjacent lane at a high rate of speed. If the driver activates the turn signal when the system detects an oncoming vehicle, the system sounds an audible alert. Distance from the approaching vehicle can be seen differently according to the relative speed.
(3) RCCW (Rear Cross-Traffic Collision Warning)
The RCCW feature monitors approaching cross traffic from the left and right side of the vehicle when your vehicle is in reverse. The feature will operate when the vehicle is moving in reverse below about 6 mph (10 km/h). If oncoming cross traffic is detected a warning chime will sound.
Distance from the approaching vehicle can be seen differently according to the relative speed.
WARNING
The drive mode may be selected according to the driver's preference or road condition. The system resets to be in the NORMAL mode (except if it is in ECO mode), when the engine is restarted.
Operating conditions To operate: Press the BCW switch with the Ignition switch in the ON position. The indicator on the BCW switch will illuminate.
The Driver Attention Warning (DAW) system displays the condition of the driver's fatigue level and inattentive driving practices. System setting and activation System setting The Driver Attention Warning (DAW) system is set to be in the OFF position, when your vehicle is first delivered to you from the factory.
Since the sidewalls of radial tyres are thinner than other types of tyres, they may be damaged by mounting some types of tyre chains on them. Therefore, the use of snow tyres is recommended instead of tyre chains. Do not mount tyre chains on vehicles equipped with aluminium wheels; if unavoidable use a wire or fabric type snow ch