Hyundai i30 (PD): Convenient features of your vehicle / Mounting bracket for roof carrier

Hyundai i30. Mounting bracket for roof carrier

To install or remove a roof carrier, you can use the mounting bracket and cover on the roof.

When you install a roof carrier, use the following procedure.

1. Insert a slim tool(coin or flat blade driver) into the slot and slide the cover toward the arrow on the cover.

Hyundai i30. Mounting bracket for roof carrier

2. Rotate the cover half way and insert the cover on the roof hole as the illustration.

3. After using the roof carrier, install the cover back on the roof in the reverse order.

Information

If the vehicle is equipped with a sunroof, be sure not to position cargo onto the roof in such a way that it could interfere with sunroof operation.

NOTICE

  • When carrying cargo on the roof, take the necessary precautions to make sure the cargo does not damage the roof of the vehicle.
  • When carrying large objects on the roof, make sure they do not exceed the overall roof length or width.

    The luggage rail system may help prevent the luggage from rolling around in the luggage compartment. Build in segmentation bar Put both pillars (A) of the segmentation bar on the rail openings.

    WARNING Carbon monoxide (CO) gas is toxic. Breathing CO can cause unconsciousness and death. Engine exhaust contains carbon monoxide which cannot be seen or smelled.

    Other information:

    Hyundai i30 (PD) 2018-2024 Owner's Manual: TPMS (Tyre Pressure Monitoring System) malfunction indicator

    The TPMS malfunction indicator will illuminate after it blinks for approximately one minute when there is a problem with the Tyre Pressure Monitoring System. We recommend that the system be checked by a HYUNDAI authorised repairer. NOTICE If there is a malfunction with the TPMS, the low tyre pressure position telltale will not

    Hyundai i30 (PD) 2018-2024 Owner's Manual: Front fog lamp

    â–  Type A â–  Type B 1. Loosen the pin-type retainers of the under cover and then remove the undercover. 2. Reach your hand into the back of the front bumper. 3. Disconnect the power connector from the socket. 4. Remove the bulb-socket from the housing by turning the socket counterclockwise until the tabs on the socket align

    Categories

     
    Copyright © 2026 www.hi30.net - 0.0131