Hyundai i30 (PD): Smart cruise control (SCC) with stop & go system / Sensor to detect distance to the vehicle ahead
The Smart Cruise Control uses a sensor to detect distance to the vehicle ahead.
Warning message
SCC (Smart Cruise Control) disabled. Radar blocked
When the sensor lens cover is blocked with dirt, snow, or debris, the Smart Cruise Control System operation may stop temporarily. If this occurs, a warning message will appear on the LCD display. Remove any dirt, snow, or debris and clean the radar sensor lens cover before operating the Smart Cruise Control System.
The Smart Cruise Control system may not properly activate, if the radar is totally contaminated, or if any substance is not detected after turning ON the engine (e.g. in an open terrain).
Information
For the SCC operation is temporarily stopped if the radar is blocked, but you wish to use cruise control mode (speed control function), you must convert to the cruise control mode (refer to “To convert to Cruise Control mode” in the following page.
CAUTION
- Do not apply license plate frame or foreign objects such as a bumper sticker or a bumper guard near the radar sensor. Doing so may adversely affect the sensing performance of the radar.
- Always keep the radar sensor and lens cover clean and free of dirt and debris.
- Use only a soft cloth to wash the vehicle. Do not spray pressurized water directly on the sensor or sensor cover.
- Be careful not to apply unnecessary force on the radar sensor or sensor cover. If the sensor is forcibly moved out of proper alignment, the Smart Cruise Control System may not operate correctly. In this case, a warning message may not be displayed. Have the vehicle inspected by a HYUNDAI authorised repairer.
- If the front bumper becomes damaged in the area around the radar sensor, the Smart Cruise Control System may not operate properly. We recommend that you have the vehicle inspected by a HYUNDAI authorised repairer.
- Use only genuine HYUNDAI parts to repair or replace a damaged sensor or sensor cover. Do not apply paint to the sensor cover.
Check SCC (Smart Cruise Control) system
The message will appear when the vehicle to vehicle distance control system is not functioning normally.
We recommend that you take your vehicle to a HYUNDAI authorised repairer and have the system checked.
To set Vehicle-to-Vehicle Distance When the Smart Cruise Control System is ON, you can set and maintain the distance from the vehicle ahead of you without pressing the accelerator or brake pedal.
The sensitivity of vehicle speed when following the front vehicle to maintain the set distance can be adjusted. Go to the 'User Settings → Driving Assist → Smart Cruise Control Speed → Slow/Normal/ Fast' on the LCD display.
Other information:
Hyundai i30 (PD) 2018-2024 Owner's Manual: Check tyre pressure
You can check the tyre pressure in the Assist mode on the cluster. Refer to the "LCD Display Modes" in chapter 3. Tyre pressure is displayed after a few minutes of driving after initial engine start up. If tyre pressure is not displayed when the vehicle is stopped, "Drive to display" message will appear.
Hyundai i30 (PD) 2018-2024 Owner's Manual: Exterior care
Exterior general caution It is very important to follow the label directions when using any chemical cleaner or polish. Read all warning and caution statements that appear on the label. Finish maintenance Washing To help protect your vehicle’s finish from rust and deterioration, wash it thoroughly and frequently at least once a
Categories
- Manuals Home
- Hyundai i30 Owners Manual
- Drive mode integrated control system
- Your vehicle at a glance
- Maintenance
- New on site
- Most important about car
