Hyundai i-30: Lighting / Static bending light
Whilst driving a corner, for greater
visibility and safety, either the left or
right side static bending light will turn
on automatically. The static bending
light will turn on when one of the following
conditions occur.
- Vehicle speed is less than 6 mph
(10 km/h) and steering wheel angle
is turned approximately 80 degrees
with the low beam on.
- Vehicle speed is between 6 mph
(10km/h) to 56 mph (90 km/h) and
steering wheel angle is turned
approximately 35 degrees with the
low beam on.
- When the vehicle is in reverse with
one of the conditions above satisfied,
the light opposite to the direction
the steering wheel is steered
will turn on.
Daytime running light (DRL)
The Daytime Running Lights (DRL)
can make it easier for others to see
the front of your vehicle during the
day, especially after dawn and before
sunset...
Welcome light
Puddle lamp
When all the doors (and tailgate) are
closed and locked, the puddle lamp
will come on for about 15 seconds if
any of the below is performed...
Other information:
This information identifies and
describes the fundamental characteristics
of the tyre and also provides
the tyre identification number (TIN)
for safety standard certification. The
TIN can be used to identify the tyre in
case of a recall.
1...
The rear window wiper and washer
switch is located at the end of the
wiper and washer switch lever.
Turn the switch to the desired position
to operate the rear wiper and
washer.
2 – High wiper speed
1 – Low wiper speed
O – Off
Push the lever away from you to
spray rear washer fluid and to run the
rear wipers 1~3 cycles...
Categories
Opening the bonnet

1. Park the vehicle and set the parking
brake.
2. Pull the release lever to unlatch
the bonnet. The bonnet should
pop open slightly.

read more