Check LKA system

If there is a problem with the system a message will appear for a few seconds. If the problem continues the LKA system failure indicator will illuminate.
LKA system failure indicator

The LKA system failure indicator (yellow) will illuminate if the LKA system is not working properly. We recommend that the system be checked by a HYUNDAI authorised repairer.
When there is a problem with the system do one of the following:
If the problem is not solved, we recommend that the system be checked by a HYUNDAI authorised repairer.
The LKA system will not be in the ENABLED state and the steering wheel will not be assisted when:
To activate/deactivate the LKA system: With the ignition switch in the ON position, press the LKA system button located on the instrument panel on the right hand side of the steering wheel.
The LKA system may operate prematurely even if the vehicle does not depart from the intended lane, OR, the LKA system may not warn you if the vehicle leaves the intended lane under the following circumstances: When the lane and road conditions are poor It is difficult to distinguish the lane marking from the road surface or the lane marking is faded or not clearly marked.
Since the sidewalls of radial tyres are thinner than other types of tyres, they may be damaged by mounting some types of tyre chains on them. Therefore, the use of snow tyres is recommended instead of tyre chains. Do not mount tyre chains on vehicles equipped with aluminium wheels; if unavoidable use a wire or fabric type snow ch
You can check the tyre pressure in the Assist mode on the cluster. Refer to the "LCD Display Modes" in chapter 3. Tyre pressure is displayed after a few minutes of driving after initial engine start up. If tyre pressure is not displayed when the vehicle is stopped, "Drive to display" message will appear.