Hyundai i-30: Wipers and washers / Windscreen wipers
Operates as follows when the ignition
switch is turned ON.
: For a single wiping cycle, move
the lever down and release it.
The wipers will operate continuously
if the lever is held in this
position.
O : Wiper is not in operation
--- : Wiper operates intermittently at
the same wiping intervals.
Use this mode in light rain or
mist. To vary the speed setting,
turn the speed control knob.
1 : Normal wiper speed
2 : Fast wiper speed
Information
If there is heavy accumulation of snow
or ice on the windscreen, defrost the
windscreen for about 10 minutes, or
until the snow and/or ice is removed
before using the windscreen wipers to
ensure proper operation.
If you do not remove the snow and/or ice
before using the wiper and washer, it may
damage the wiper and washer system.
The rain sensor located on the upper
end of the windscreen glass senses
the amount of rainfall and controls
the wiping cycle for the proper interval...
Other information:
..
The SRS consists of the following
components:
(1) Driver's front air bag module/
Driver’s knee air bag module
(2) Passenger's front air bag module
(3) Side air bag modules/
Side impact sensors
(4) Curtain air bag modules
(5) Rear Retractor pre-tensioner
(6) Retractor pre-tensioner assemblies
(7) Air bag warning light
(8) SRS control module (SRSCM)/
Rollover sensor
(9) Front impact sensors
(10) Side pressure sensors
(11) Passenger’s front air bag
ON/OFF indicator
(12) Passenger’s front air bag
ON/OFF switch
The SRSCM continually monitors all
SRS components whilst the ignition
switch is ON to determine if a crash
impact is severe enough to require
air bag deployment or pre-tensioner
seat belt deployment...
Categories
Opening the tailgate

■ 5 Door, Wagon

■ Fastback
read more