Hyundai i30 (PD): Windscreen defrosting and defogging / Manual climate control system

To defog inside windscreen

Hyundai i30. Manual climate control system

1. Select any fan speed except “0” position.

2. Select the desired temperature.

3. Select the Hyundai i30. Manual climate control system or Hyundai i30. Manual climate control system position.

4. The outside (fresh) air will be selected automatically. Additionally, the air conditioning (if equipped) will automatically operate if the mode is selected to the Hyundai i30. Manual climate control system position.

If the air conditioning and outside (fresh) air position are not selected automatically, press the corresponding button manually.

To defrost outside windscreen

Hyundai i30. Manual climate control system

1. Set the fan speed to the highest (extreme right) position.

2. Set the temperature to the extreme hot position.

3. Select the Hyundai i30. Manual climate control system position.

4. The outside (fresh) air and air conditioning (if equipped) will be selected automatically.

    WARNING Windscreen heating Do not use the or position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windscreen could cause the outer surface of the windscreen to fog up, causing loss of visibility.

    To defog inside windscreen 1. Select the desired fan speed. 2. Select the desired temperature. 3. Press the defroster button (). 4. The air-conditioning will turn on according to the detected ambient temperature, outside (fresh) air position and higher fan speed will be selected automatically.

    Other information:

    Hyundai i30 (PD) 2018-2024 Owner's Manual: Removable towing hook

    1. Open the tailgate, and remove the towing hook from the tool case. ■ Front ■ Rear 2. Remove the hole cover pressing the lower part of the cover on the bumper. 3. Install the towing hook by turning it clockwise into the hole until it is fully secured.

    Hyundai i30 (PD) 2018-2024 Owner's Manual: Front fog lamp

    ■ Type A ■ Type B 1. Loosen the pin-type retainers of the under cover and then remove the undercover. 2. Reach your hand into the back of the front bumper. 3. Disconnect the power connector from the socket. 4. Remove the bulb-socket from the housing by turning the socket counterclockwise until the tabs on the socket align

    Categories

     
    Copyright © 2025 www.hi30.net - 0.0084