Hyundai i30 (PD): Idle stop and go (ISG) system / To deactivate the ISG system, ISG system malfunction
To deactivate the ISG system
- Press the ISG OFF button to deactivate the ISG system. Then, the ISG OFF button indicator illuminates, and the message "Auto Stop System Off" appears on the LCD display.
- Press the ISG OFF button again to reactivate the ISG system. Then, the ISG OFF button indicator turns OFF.
ISG system malfunction
The ISG system may not operate:
When there is a malfunction with the ISG sensors or the ISG system.
The followings occur, when there is a malfunction with the ISG system:
- The auto stop indicator (
)
remains ON in yellow after blinking
for 5 seconds on the instrument
cluster. - The light on the ISG OFF button will illuminate.
Information
- When you cannot turn OFF the ISG OFF button indicator by pressing the ISG OFF button, or when the malfunction with the ISG system persists, we recommend that you contact a HYUNDAI authorised repairer.
- You can turn off the ISG OFF button indicator by driving over 50 mph (80 km/h) for up to 2 hours with the fan speed below the 2nd position. If the ISG OFF button indicator remains ON, we recommend that you contact a HYUNDAI authorised repairer.
WARNING
When the engine is in auto stop mode, the engine may restart. Before leaving the vehicle or checking the engine compartment, stop the engine by placing the ignition switch to the LOCK/OFF position or removing the ignition key.
Prerequisite for activation The ISG system operates in the following situations. - The driver's seatbelt is fastened. - The driver's door and the bonnet are closed.
The battery sensor is deactivated, when the battery is disconnected from the negative pole for maintenance purpose. In this case, the ISG system is limitedly operated due to the battery sensor deactivation.
Other information:
Hyundai i30 (PD) 2018-2024 Owner's Manual: Wheel alignment and tyre balance
The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tyre life and best overall performance. In most cases, you will not need to have your wheels aligned again. However, if you notice unusual tyre wear or your vehicle pulling one way or the other, the alignment may need to be reset.
Hyundai i30 (PD) 2018-2024 Owner's Manual: Tyre replacement
If the tyre is worn evenly, a tread wear indicator will appear as a solid band across the tread. This shows there is less than 1/16 in. (1.6 mm) of tread left on the tyre. Replace the tyre when this happens. Do not wait for the band to appear across the entire tread before replacing the tyre.
Categories
- Manuals Home
- Hyundai i30 Owners Manual
- LKA system operation
- Your vehicle at a glance
- Specifications & Consumer information
- New on site
- Most important about car
