Hyundai i-30: Remote key / Battery replacement

Hyundai i30 (PD) 2018-2022 Owner's Manual / Convenient features of your vehicle / Accessing your vehicle / Remote key / Battery replacement

If the remote key is not working properly, try replacing the battery with a new one.

Hyundai i30. Battery replacement

Battery Type: CR2032

To replace the battery:

1. Insert a slim tool into the slot and gently pry open the cover.

2. Using a screw driver, remove the battery cover.

3. Remove the old battery and insert a new battery. Make sure the battery position is correct.

4. Reinstall the battery cover and key cover in the reverse order of removal.

If you suspect your remote key might have sustained some damage, or you feel your remote key is not working correctly, it is recommended that you contact a HYUNDAI authorised repairer.

Information

An inappropriately disposed battery can be harmful to the environment and human health. Dispose of the battery according to your local law(s) or regulations.

Remote key precautions

The remote key will not work if any of the following occur: The key is in the ignition switch. You exceed the operating distance limit (about 30 m [90 feet])...

Smart key

Your HYUNDAI uses a Smart Key, which you can use to lock or unlock a door (and tailgate) and even start the engine. 1. Door Lock 2. Door Unlock 3...

Other information:

Hyundai i30 (PD) 2018-2022 Owner's Manual: Limitations of the System

The LKA system may operate prematurely even if the vehicle does not depart from the intended lane, OR, the LKA system may not warn you if the vehicle leaves the intended lane under the following circumstances: When the lane and road conditions are poor It is difficult to distinguish the lane marking from the road surface or the lane marking is faded or not clearly marked...

Hyundai i30 (PD) 2018-2022 Owner's Manual: Rear fog lamp

1. Loosen the pin-type retainers and screws of the rear wheel guard and then detach it from the rear bumper. 2. Reach your hand into the back of the rear bumper. 3. Remove the socket from the housing by turning the socket counterclockwise until the tabs on the socket align with the slots of the housing...