Hyundai i-30: Engine Control System / Differential Pressure Sensor (DPS)

Hyundai i30 (PD) 2018-2025 Service Manual / Engine Control / Fuel System / Engine Control System / Differential Pressure Sensor (DPS)

Description and operation

Description

Differential Pressure Sensor (DPS) is measure the pressure difference of EGR inlet and outlet.

Schematic diagrams

Circuit Diagram

Harness Connector

Repair procedures

Removal

1.	Turn the ignition swtich OFF, and then disconnect the battery negative (-) terminal.

2.	Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")

3.	Remove the differential pressure valve. (Refer to Engine Control System - "Differential Pressure Valve (DPV)")

4.	Disconnect the DPS connector (A).

5.	Disconnect the DPS hose (A).

Remove the DPS (B) after loosening the mounting bolt.

Tightening Torque :

6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb.ft)

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

1.	Install in the reverse order of removal.

Injector

Description and operation Description The GDI injector is similar to a standard injector, but sprays fuel at a much higher pressure directly into the combustion chamber and has a swirl disc to get the fuel swirling as it exits the nozzle...

Exhaust Gas Temperature Sensor (EGTS)

Description and operation Description Exhaust Gas Temperature Sensor (EGTS) is installed on Gasoline Particulate Filter (GPF) senses the temperature of exhaust gas flowing into...

Other information:

Hyundai i30 (PD) 2018-2025 Owner's Manual: Wheel alignment and tyre balance

The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tyre life and best overall performance. In most cases, you will not need to have your wheels aligned again. However, if you notice unusual tyre wear or your vehicle pulling one way or the other, the alignment may need to be reset...

Hyundai i30 (PD) 2018-2025 Service Manual: Repair procedures

Removal [Gasoline 1.0 T-GDI] 1. Remove the snap pins (A) and the regulator (B). • Do not spill brake fluid on the vehicle it may damage the paint if brake fluid does contact the paint, wash it off immediately with water...