
1. Loosen the pin-type retainers and screws of the rear wheel guard and then detach it from the rear bumper.
2. Reach your hand into the back of the rear bumper.
3. Remove the socket from the housing by turning the socket counterclockwise until the tabs on the socket align with the slots of the housing.
4. Remove the bulb from the socket by pressing it in and rotating it counterclockwise until the tabs on the bulb align with the slots in the socket. Pull the bulb out of the socket.
5. Insert a new bulb by inserting it into the socket and rotating it until it locks into place.
6. Install the socket into the housing by aligning the tabs on the socket with the slots in the housing. Push the socket into the housing and turn the socket clockwise.
Rear fog lamp (Fastback (N Line))
If the LED lamp does not operate, we recommend that you have the vehicle checked by a HYUNDAI authorised repairer.
Type A (5 Door) Type B (5 Door) Type C (5 Door, 5 Door (N Line)) (1) Stop/Tail lamp (2) Turn signal lamp (3) Tail lamp (4) Backup lamp (5) Stop lamp Stop/Tail lamp (Type A) and turn signal lamp 1.
If the high mounted stop lamp does not operate, we recommend that you contact a HYUNDAI authorised repairer.
The high-pressure cooling system has a reservoir filled with year-round antifreeze coolant. The reservoir is filled at the factory. Check the antifreeze protection and coolant concentration level at least once a year, at the beginning of the winter season, and before travelling to a colder climate.
The emission control system of your vehicle is covered by a written limited warranty. Please see the warranty information contained in the Warranty Booklet in your vehicle. Your vehicle is equipped with an emission control system to meet all applicable emission regulations.