Hyundai i-30: Air Conditioning System / Compressor oil

Hyundai i30 (PD) 2018-2024 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Compressor oil

Repair procedures
Oil Specification
1.
The oil used to lubricate the compressor circulates with the refrigerant.
2.
Whenever replacing any component of the system or a large amount of gas leakage occurs, add oil to maintain the original amount of oil.
Handling of Oil
1.
The oil should be free from moisture, dust, metal powder, etc.
2.
Do not mix with other oil.
3.
The water content in the oil increases when exposed to air. After use, seal oil from air immediately. (R-134a Compressor Oil absorbs moisture very easily.)
4.
The compressor oil must be stored in steel containers, not in plastic containers.
Compressor Oil Check
The oil used to lubricate the compressor circulates with the refrigerant.
Whenever replacing any component of the system or a large amount of gas leakage occurs, add oil to maintain the original amount of oil.
Oil total volume in system
FD46XG(IDEMITSU) 110 ± 10cc (3.88 ± 0.35oz.)
Oil Return Operation
There is close affinity between the oil and refrigerant.
During normal operation, part of the oil recirculates with the refrigerant in the system. When checking the amount of oil in the system, or replacing any component of the system, the compressor must run in advance for oil return operation. The procedure is as follows:
1.
Open all the doors and engine hood.
2.
Start the engine and air conditioning switch to "ON" and set the blower motor control knob at its highest position.
3.
Run the compressor for more than 20 minutes between 800 and 1,000 rpm in order to operate the system.
4.
Stop the engine.

    Components and components location

    Component Location Index Engine Room 1. Expansion valve 2. Service port (Low pressure) 3. Service port (High pressure) 4...

    Refrigerant Line

    Components and components location Components Location 1. Suction & Liquid tube assembly Repair procedures Replacement 1...

    Other information:

    Hyundai i30 (PD) 2018-2024 Service Manual: Wheel


    Repair procedures Hub nut tightening sequence 1. Tighten the hub nuts as follows. Tightening torque : 107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)    • When using an impact gun, final tightening torque should be checked using a torque wrench...

    Hyundai i30 (PD) 2018-2024 Service Manual: Engine Cover


    Repair procedures Removal and Installation 1. Remove the engine cover (A).    • To avoid damage, remove the engine cover on room temperature...

    Categories

    Door locks

    Operating door locks from outside the vehicle

    Mechanical key

    Hyundai i30. Door locks

    Turn the key toward the rear of the vehicle to unlock and toward the front of the vehicle to lock.

    If you lock/unlock the driver's door with a key, a driver’s door will lock/unlock automatically.

    read more


     
    Copyright © 2024 www.hi30.net