Hyundai i-30: Hood / Hood Latch

Hyundai i30 (PD) 2018-2025 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch

Components and components location

Component Location

1. Hood latch assembly

Repair procedures

Replacement

1.	Disconnect the hood latch connector (A).

2.	Disconnect the hood latch wiring (A).

3.	Loosen the mounting bolts and remove the hood lower latch assembly (A).

4.	Disconnect the hood latch cable (A) and remove the hood latch (B).

To install, reverse removal procedure.

•	Make sure the hood latch release cable is connected properly.

•	Make sure the hood locks/unlocks and opens/closes properly.

•	Adjust the latch alignment.

•	Replace any damaged clips (or retainers or fasteners)

Hood Latch Release Handle

Components and components location Component Location 1. Hood latch release handle Repair procedures Replacement 1...

Other information:

Hyundai i30 (PD) 2018-2025 Service Manual: Water Jacket Seperator

Repair procedures Removal and Installation 1. Remove the cylinder head assembly. (Refer to Cylinder Head Assembly - "Cylinder Head") 2. Remove the water jacket separator (A)...

Hyundai i30 (PD) 2018-2025 Owner's Manual: Bonnet

Opening the bonnet 1. Park the vehicle and set the parking brake. 2. Pull the release lever to unlatch the bonnet. The bonnet should pop open slightly. 3. Go to the front of the vehicle, raise the bonnet slightly, push the secondary latch up (1) inside of the bonnet centre and lift the bonnet (2)...