Hyundai i-30: Body (Interior and Exterior) / Hood

Repair procedures

Replacement    • When removing the fender, wrap protective tape around a screwdriver or remover not to damage components • Put on gloves to prevent hand injuries    • When removing the clips, use a clip remover...

Repair procedures

Adjustment 1. After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up and down or from side to side and tighten the bolt...

Other information:

Hyundai i30 (PD) 2018-2025 Service Manual: Mass Air Flow Sensor (MAFS)

Description and operation Description MAFS uses a hot-film type sensing element to measure the mass of intake air entering the engine, and send the signal to ECM. A large amount of intake air represents acceleration or high load conditions while a small amount of intake air represents deceleration or idle...

Hyundai i30 (PD) 2018-2025 Service Manual: Rear Assist Arm

Repair procedures Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securelysupported. 2. Remove the rear wheel and tire (A) from the raerhub...