Hyundai i-30: Fuses And Relays / ICM (Integrated Circuit Module) Relay Box
Description and operation
The ICM relay is united with (rear wiper relay, seat heater relay(front/rear),
head lamp washer relay and rear A/C relay) which installed inside the lower
crash pad.

Repair procedures
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the main crash pad assembly.
(Refer to Body - "Main Crash Pad Assembly")
|
3. |
Remove the ICM relay box after mouting nuts and disconnecting the connector
(B).
|
1. |
Install the main crash pad assembly after connecting the connector.
|
2. |
Install the main crash pad assembly.
|
3. |
Connect the negative (-) battery terminal.
|
Components and components location
Component Location
[Interior Junction Block]
IGPM(Integrated Gateway & Power Control
Module)
Circuit (IGPM)
Description and operation
Description
Communication Network Diagram
Abbreviation
Expalnation
ECM
Engine Control Module
TCU
Transmission Control Unit
MDPS
Motor Driven Power Steering
AEB
Autonomous Emergency Braking
LKAS
Lane Keeping Assist System
FPS
Fuel Pump Control module
RR CAMERA
Rear View Carmera
VACUUM
Vacuum Pump
CLUSTER
Cluster Module
ACU
Airbag Control Unit
DATC
Dual Automatic Temp Control
MTC
Temp Control
OCS
Occupant Classification System
VDC
Vehicle Dynamic Control
BSD
Blind Spot Detection
AMP
Amplifier
AVN
Head Unit (Audio / AVN)
SMK
Smart Key Unit
WPC
Wireless Power Charger
IMS
Integrated Memory System
DDM
Driver Door Module
ADM
Assist Door Module
BCM
Body Control Module
B-CAN
Body Controller Area Network
P-CAN
Powertrain Controller Area Network
M-CAN
Multi media Controller Area Network
C-CAN
Chassis Controller Area Network
Integrated Gateway & Power control Module (IGPM)
Integrated Gateway & Power control Module (IGPM) is a module that performs the
function of conventional Junction Block and some functions of BCM...
Other information:
Vehicle with front fog lamp
To turn on the rear fog lamp:
Position the light switch in the position
lamp position, turn the light
switch (1) to the front fog lamp position,
and then turn the light switch (1)
to the rear fog lamp position.
To turn the rear fog lamps off, do one
of the following:
Turn off the position light switch...
Repair procedures
Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower resistor
must be replaced. (After removing the resistor)
Replacement
1...
Categories
Opening the tailgate

■ 5 Door, Wagon

■ Fastback
read more