Hyundai i-30: Light bulbs / Interior light bulb replacement
Room lamp

If the LED lamp does not operate, we
recommend that you have the vehicle
checked by a HYUNDAI authorised
repairer.
Map lamp, room lamp, vanity mirror lamp and luggage compartment lamp



1. Using a flat-head screwdriver,
gently pry the lens from the interior
light housing.
2. Remove the bulb by pulling it
straight out.
3. Install a new bulb into the socket.
4. Align the lens tabs with the interior
light housing notches and snap
the lens into place.
NOTICE
Be careful not to damage the
cover, tab, and plastic housing.
1. Using a flat-blade screwdriver,
gently pry the lens cover from the
lamp housing.
2. Remove the bulb by pulling it
straight out.
3. Install a new bulb...
Exterior general caution
It is very important to follow the label
directions when using any chemical
cleaner or polish. Read all warning
and caution statements that appear
on the label...
Other information:
The SRS consists of the following
components:
(1) Driver's front air bag module/
Driver’s knee air bag module
(2) Passenger's front air bag module
(3) Side air bag modules/
Side impact sensors
(4) Curtain air bag modules
(5) Rear Retractor pre-tensioner
(6) Retractor pre-tensioner assemblies
(7) Air bag warning light
(8) SRS control module (SRSCM)/
Rollover sensor
(9) Front impact sensors
(10) Side pressure sensors
(11) Passenger’s front air bag
ON/OFF indicator
(12) Passenger’s front air bag
ON/OFF switch
The SRSCM continually monitors all
SRS components whilst the ignition
switch is ON to determine if a crash
impact is severe enough to require
air bag deployment or pre-tensioner
seat belt deployment...
Repair procedures
Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from the front hub...
Categories
Seat belt warning
Driver’s seat belt warning

■ Instrument cluster
As a reminder to the driver, the seat
belt warning light will illuminate for
approximately 6 seconds each time
you turn the ignition switch ON
regardless of belt fastening.
read more