Hyundai i-30: Panorama sunroof / Panorama Sunroof Frame Weatherstrip
Repair procedures
1. |
Remove the movable glass.
(Panorama sunroof - refer "movable glass")
|
2. |
Remove the panorama sunroof frame weather strip (A).

|
1. |
Remove the double side tape and apply primer [81685-3S000] (A).

|
2. |
Install the Panorama sunroof frame weather strip (A).

• |
Make sure air vent hole is placed at the rear, attach
strip in order of front → side → rear.
|
• |
Working with two people from left and right can make
strip attached in astraight line.
|
• |
Attach strip after checking interior or exterior due
to unsymmetry.
|
• |
Panorama sunroof frame weather strip can not be reusable.
Replace new one when movable or exchange.


|
|
|
Repair procedures
Removal
•
In order to remove panorama sunroof assembly use tools as follows...
Repair procedures
Replacement
1.
Remove the movable glass.
(Panorama sunroof - refer "movable glass")
2...
Other information:
Repair procedures
Inspection
Check if the auto light control operates like a timing chart shown below. Tail
lamp output and head lamp (Low) output is controlled based on the auto light
sensor's input (illumination intensity) when the Auto Light Switch in Multi-Function
Switch is turned ON, and the vehicle is in IGN1 or IGN2 ON Mode...
Components
The following is the configuration of the AEB system.
–
Detection device (radar and camera) that can recognize potential obstacles
in the front.
–
Human-Machine Interface (HMI) to warn driver or change settings...
Categories

When the High Beam Assist (HBA)
System is not working properly, the
warning message will come on for a
few second. After the message disappears,
the master warning light (
)
will illuminate.
read more