Hyundai i-30: Front Bumper / Radiator Grill
Components and components location
Repair procedures
| •
|
Put on gloves to prevent hand injuries.
|
|
| •
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
| •
|
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
| •
|
Take care not to bend or scratch the trim and panels.
|
|
|
1. |
Remove the front bumper assembly.
(Refer to Front Bumper - "Front Bumper Assembly")
|
|
2. |
Remove the front bumper energy absorber (A).
|
|
3. |
After loosening the mounting screws, remove the radiator grill side
bracket (A).
|
|
4. |
To install, reverse removal procedure.
|
• |
Replace any damaged clips (or pin-type retainers).
|
|
|
Components and components location
Component Location
1. Front bumper
assembly
Repair procedures
Replacement
•
Put on gloves to prevent hand injuries...
Other information:
Description and operation
Description
The Electric EGR Control Valve is installed in between the EGR cooler and the
exhaust line and is a solenoid valve. This valve controls EGR (Exhaust Gas Recirculation)
amount by the ECM's duty control signal depending on engine load and the need
of intake air...
The High Beam Assist (HBA) is a
system that automatically adjusts the
headlamp range (switches between
high beam and low beam) according
to the brightness of other vehicles
and road conditions.
Operating condition
1.Place the light switch in the AUTO
position...
Categories
To signal a turn, push down on the
lever for a left turn or up for a right
turn in position (A). To signal a lane
change, move the turn signal lever
slightly and hold it in position (B).The
lever will return to the OFF position
when released or when the turn is
completed.
read more
Front Bumper Assembly
Rear Bumper