Hyundai i-30: Interior Trim / Rear Transverse Trim
Components and components location

Repair procedures
•
|
Put on gloves to prevent hand injuries.
|
|
•
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
•
|
When removing the interior trim pieces, use a plastic panel
removal tool not to damage the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Remove the luggage covering mat (A).

|
2. |
Loosen the mounting clips and remove the rear transverse trim (A).

|
3. |
To install, reverse removal procedure.
• |
Replace any damaged clips (or pin-type retainers).
|
|
|
Components and components location
Component Location
1. Center pillar
lower trim
2. Center pillar
upper trim
Repair procedures
Replacement
[Center pillar lower trim]
•
Put on gloves to prevent hand injuries...
Components and components location
Component Location
1. Luggage side
trim
Repair procedures
Replacement
•
Put on gloves to prevent hand injuries...
Other information:
1. Loosen the pin-type retainers and
screws of the rear wheel guard
and then detach it from the rear
bumper.
2. Reach your hand into the back of
the rear bumper.
3. Remove the socket from the housing
by turning the socket counterclockwise
until the tabs on the
socket align with the slots of the
housing...
Description
•
Components location : DCT (Dual Clutch Transmission)
•
Function
The dual clutch is installed within the transmission.
The dual clutch comprises an odd clutch and an even clutch...
Categories
Opening the bonnet

1. Park the vehicle and set the parking
brake.
2. Pull the release lever to unlatch
the bonnet. The bonnet should
pop open slightly.

read more