Hyundai i-30: Trunk Trim / Repair procedures
•
|
Put on gloves to prevent hand injuries.
|
|
•
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
•
|
When removing the interior trim pieces, use a plastic panel
removal tool not to damage the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
|
2. |
Remove the rear seat back assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
|
3. |
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
|
4. |
Remove the cargo screen (A).
|
5. |
Remove the luggage covering mat & board (B).
|
6. |
After loosening the mounting bolt, remove the shift side trim covering
(C).
|
7. |
Remove the rear transverse trim (D).
|
8. |
After loosening the mounting screws, remove the luggage side trim (E).
|
9. |
To install, reverse removal procedure.
• |
Replace any damaged clips.
|
|
[Mat type]

1. Cargo
screen
2. Luggage covering mat & board
3. Shift side trim covering [LH]
4. Shift side trim covering [RH]
|
5. Rear
transverse trim
6. Luggage side trim [LH]
7. Luggage side trim [RH]
|
[Board type]

1. Cargo
screen
2. Luggage covering mat & board
3. Shift side trim covering [LH]
4. Shift side trim covering [RH]
|
5. Rear
transverse trim
6. Luggage side trim [LH]
7. Luggage side trim [RH]
|
|
Other information:
Repair procedures
Removal and installation
1.
Remove the engine room under cover (A).
Tightening torque :
3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)
2...
Description and operation
Airbag Disposal
When you scrap a vehicle equipped with an airbag, you must deploy it first.
When you deploy an airbag, you need to have a skilled mechanic do the work.
The used airbag should not be reinstalled in another vehicle for reuse...
Categories

To signal a turn, push down on the
lever for a left turn or up for a right
turn in position (A). To signal a lane
change, move the turn signal lever
slightly and hold it in position (B).The
lever will return to the OFF position
when released or when the turn is
completed.
read more