Hyundai i-30: Warning and indicator lights / Turn Signal Indicator
Light. Low Beam Indicator
Light. High Beam Indicator
Light
Turn Signal Indicator
Light

This indicator light blinks:
• When you operate the turn signals.
If any of the following occur, there may
be a malfunction with the turn signal
system.
- The turn signal indicator light illuminates
but does not blink
- The turn signal indicator light blinks
rapidly
- The turn signal indicator light does
not illuminate at all
If any of these conditions occur, we
recommend that you have your vehicle
inspected by a HYUNDAI authorised
repairer.
Low Beam Indicator
Light

This indicator light illuminates:
• When the headlights are on.
High Beam Indicator
Light

This indicator light illuminates:
- When the headlamps are on and in
the high beam position.
- When the turn signal lever is pulled
into the Flash-to-Pass position.
AUTO STOP Indicator
Light
This indicator light illuminates:
• When the engine enters the Idle
Stop mode of the ISG (Idle Stop and
Go) system...
High Beam Assist
(HBA) Indicator Light
This warning light illuminates:
When the high-beam is on with the
light switch in the AUTO light position...
Other information:
Headlamp aiming
1. Inflate the tyres to the specified
pressure and remove any loads
from the vehicle except the driver,
spare tyre, and tools.
2. The vehicle should be placed on a
flat floor.
3. Draw vertical lines (Vertical lines
passing through respective head
lamp centres) and a horizontal line
(Horizontal line passing through
centre of head lamps) on the
screen...
To turn on the high beam headlamp,
push the lever away from you. The
lever will return to its original position.
The high beam indicator will light
when the headlamp high beams are
switched on.
To turn off the high beam headlamp,
pull the lever towards you...
Categories

To signal a turn, push down on the
lever for a left turn or up for a right
turn in position (A). To signal a lane
change, move the turn signal lever
slightly and hold it in position (B).The
lever will return to the OFF position
when released or when the turn is
completed.
read more