Hyundai i30 (PD): Why didn't my air bag go off in a collision? / Air bag collision sensors

WARNING

To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

  • Do not hit or allow any objects to impact the locations where air bags or sensors are installed.
  • Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should.
  • Do not install bumper guards or replace the bumper with a nongenuine part.This may adversely affect the collision and air bag deployment performance.
  • Place the ignition switch to the LOCK/OFF or ACC position, when the vehicle is being towed to prevent inadvertent air bag deployment.
  • We recommend that all air bag repairs are conducted by a HYUNDAI authorised repairer.

Hyundai i30. Air bag collision sensors

1. SRS control module
2. Front impact sensor
3. Side pressure sensor (front)*
4. Side impact sensor (rear)

Hyundai i30. Air bag collision sensors

Hyundai i30. Air bag collision sensors

    There are certain types of accidents in which the air bag would not be expected to provide additional protection. These include rear impacts, second or third collisions in multiple impact accidents, as well as low speed impacts.

    Front air bags Front air bags are designed to inflate in a frontal collision depending on the severity, speed or angles of impact of the front collision.

    Other information:

    Hyundai i30 (PD) 2018-2024 Owner's Manual: Climate control air filter

    Filter inspection If the vehicle is operated in the severely air-polluted cities or on dusty rough roads for a long period, it should be inspected more frequently and replaced earlier. When you, the owner, replace the climate control air filter, replace it performing the following procedure, and be careful to avoid damaging other c

    Hyundai i30 (PD) 2018-2024 Owner's Manual: Front fog lamp

    ■ Type A ■ Type B 1. Loosen the pin-type retainers of the under cover and then remove the undercover. 2. Reach your hand into the back of the front bumper. 3. Disconnect the power connector from the socket. 4. Remove the bulb-socket from the housing by turning the socket counterclockwise until the tabs on the socket align

    Categories

     
    Copyright © 2025 www.hi30.net - 0.0081