Hyundai i30 (PD): Installing a Child Restraint System (CRS) / Securing a Child Restraint System with a lap/shoulder belt
When not using the ISOFIX system, all Child Restraint Systems must be secured to a rear seat with the lap part of a lap/shoulder belt.
Installing a Child Restraint System with a lap/shoulder belt
To install a Child Restraint System on the rear seats, do the following:
1. Place the Child Restraint System on a rear seat and route the lap/ shoulder belt around or through the Child Restraint System, following the Child Restraint System manufacturer’s instructions. Make sure the seat belt webbing is not twisted.
2. Fasten the lap/shoulder belt latch into the buckle. Listen for the distinct “click” sound.
Information
Position the release button so that it is easy to access in case of an emergency.
3. Remove as much slack from the belt as possible by pushing down on the Child Restraint System whilst feeding the shoulder belt back into the retractor.
4. Push and pull on the Child Restraint System to confirm that the seat belt is holding it firmly in place.
If your Child Restraint System manufacturer recommends the use of a top-tether with the lap/shoulder belt, see page 2-40.
To remove the Child Restraint System, press the release button on the buckle and then pull the lap/shoulder belt out of the Child Restraint System and allow the seat belt to retract fully.
IUF = suitable for ISOFIX forward child restraints systems of universal category approved for use in the mass group. IL = suitable for particular ISOFIX child restraints systems (CRS) given in the attached list.
U = Suitable for "universal" category Child Restraint Systems approved for use in this mass group. U* = Suitable for "universal" category Child Restraint Systems approved for use in this mass group (When you install the child seat on Front Passenger seat, you should move the seat position to upward and the seat back position to forward properly, to restrain child seat.
Other information:
Hyundai i30 (PD) 2018-2024 Owner's Manual: Selective Catalytic Reduction
The Selective Catalytic Reduction (SCR) system is to catalytically convert NOx to Nitrogen and Water by using the reduction agent, the urea solution. Urea gauge The urea solution gauge indicates the approximate amount of remaining urea solution inside the urea solution tank.
Hyundai i30 (PD) 2018-2024 Owner's Manual: Air conditioner compressor label, Refrigerant label, Declaration of conformity, Air conditioner compressor label
A compressor label informs you the type of compressor your vehicle is equipped with such as model, supplier part number, production number, refrigerant (1) and refrigerant oil (2). Refrigerant label The refrigerant label provides information such as refrigerant type and amount.
Categories
- Manuals Home
- Hyundai i30 Owners Manual
- Engine compartment
- Mirrors
- Recommended lubricants and capacities
- New on site
- Most important about car
