Hyundai i-30: Body Electrical System / Auto Head Lamp Leveling Device
Repair procedures
Inspection
Check if the auto light control operates like a timing chart shown below. Tail
lamp output and head lamp (Low) output is controlled based on the auto light
sensor's input (illumination intensity) when the Auto Light Switch in Multi-Function
Switch is turned ON, and the vehicle is in IGN1 or IGN2 ON Mode...
Component Location
1. Head lamp
leveling switch (Manual type only)
2. Head lamp leveling unit (Auto type only)
3...
Other information:
Repair procedures
Removal
1.
Disconnect the negative (-) battery cable.
2.
Release the parking brake.
3.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
4...
Description
Idle Stop & Go (ISG) system switches off the ignition when vehicle is stopped,
and then restarts the ignition and starts the vehicle when accelerator is pushed.
It temporarily stops the engine while waiting for signal or idling to improve
fuel efficiency and reduce exhaust gas emission...
Categories
If your vehicle is equipped with a
sunroof, you can slide or tilt your
sunroof with the sunroof control lever
located on the overhead console.

The ignition switch must be in the ON
position before you can open or
close the sunroof.
The sunroof can be operated for
approximately 30 seconds after the
ignition key is removed or turned to
the ACC or LOCK(or OFF) position.
However, if the front door is opened,
the sunroof cannot be operated even
within 30 seconds.
read more