Hyundai i-30: General Information / Description and operation
Advanced Driver Assistance System (ADAS) analyzes the exterior environment of
a vehicle and driver status to provide visibility / display / guide / warning
for driving and parking.
Item
|
Function
|
Explanation
|
Unit
|
Front Radar
|
Front View Camera
|
Rear Corner Radar
|
Rear View Camera
|
Ultrasonic Sensor
|
Driving
|
Safety
|
FCA
|
Forward Collision-Avoidance Assist
|
●
|
●
|
|
|
|
LKA
|
Lane Keeping Assist
|
|
●
|
|
|
|
DAW
|
Driver Attention Warning
|
|
●
|
|
|
|
BCW
|
Blind-Spot Collision Warning
|
|
|
●
|
|
|
BCA
|
Blind-Spot Collision-Avoidance Assist
|
|
|
●
|
|
|
HBA
|
High Beam Assist
|
|
●
|
|
|
|
Convenience
|
SCC
|
Smart Cruise Control
|
●
|
|
|
|
|
LFA
|
Lane Following Assist
|
|
●
|
|
|
|
Parking
|
Safety
|
RCCW
|
Rear Cross-Traffic Collision Warning
|
|
|
●
|
|
|
RCCA
|
Rear Cross-Traffic Collision-Avoidance Assist
|
|
|
●
|
|
|
SEA
|
Safety Exit Assist
|
|
|
●
|
|
|
RVM
|
Rear View Monitor
|
|
|
|
●
|
|
Convenience
|
PDW
|
Parking Distance Warning
|
|
|
|
|
●
|
Special Service Tools
Tool Name / Number
Illustration
Description
LKA Compensator
(09964-C1100)
Used for compensating front view camera unit
BCW Sensor Correction Tool Set
(09958-3T500)
Used to correct the blind-spot radar unit...
Other information:
The rear window wiper and washer
switch is located at the end of the
wiper and washer switch lever.
Turn the switch to the desired position
to operate the rear wiper and
washer.
2 – High wiper speed
1 – Low wiper speed
O – Off
Push the lever away from you to
spray rear washer fluid and to run the
rear wipers 1~3 cycles...
1. Move the shift lever into P (Park)
whilst the ignition switch or the
Engine Start/Stop button is in the
ON position.
2. Press the desired memory button
(1 or 2). The system will beep
once, then the driver’s seat position,
outside rearview mirror and
instrument panel illumination will
automatically adjust to the stored
position (if equipped)...
Categories

To signal a turn, push down on the
lever for a left turn or up for a right
turn in position (A). To signal a lane
change, move the turn signal lever
slightly and hold it in position (B).The
lever will return to the OFF position
when released or when the turn is
completed.
read more