Hyundai i-30: Front Door / Front Door Belt Outside Weatherstrip
Repair procedures
1. |
Pull down the front door window glass to the lowest level by pressing
the power window glass switch.
|
2. |
Using a screwdriver or remover, remove the front door belt outside weatherstrip
(A).

|
3. |
To install, reverse removal procedure.
• |
Replace any damaged clips (or pin-type retainers).
|
|
|
Components and components location
Component Location
1. Front door
latch
Repair procedures
Replacement
1...
Repair procedures
Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2...
Other information:
Air Bag Warning Light
This warning light illuminates:
When you turn the ignition switch
or the Engine Start/Stop button to
the ON position.
- It illuminates for approximately 6
seconds and then goes off.
When there is a malfunction with
the SRS...
Description and operation
Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one
of the most important sensors of the engine control system. If there is no CKPS
signal input, the engine may stop because of CKPS signal missing...
Categories

When the High Beam Assist (HBA)
System is not working properly, the
warning message will come on for a
few second. After the message disappears,
the master warning light (
)
will illuminate.
read more