Hyundai i-30: Rear Door / Rear Door Inside Handle
Repair procedures
1. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
|
2. |
After loosening the mounting screws, remove the rear door inside handle
(A).
![](images/rear_door_inside_handle-793/380/spdbd70089d_n.gif)
|
3. |
To install, reverse removal procedure.
• |
Make sure the door locks / unlocks and opens / closes
properly.
|
• |
Replace any damaged clips (or pin-type retainers).
|
|
|
Components and components location
Component Location
1. Rear door
trim
Repair procedures
Replacement
•
Put on gloves to prevent hand injuries...
Components and components location
Component Location
1. Rear door
window glass
Repair procedures
Replacement
1...
Other information:
Repair procedures
Replacement
1.
Remove the tail gate weatherstrip (A).
•
Do not apply sealant to the body...
Description and operation
Description
The fuel pump control module (FPCM) is installed on the right side of the fuel
tank and controls the DC motor mounted inside the low pressure fuel pump.The
module compares instantaneous fuel pressure information measured by the fuel
pressure sensor (FPS) with target fuel pressure information provided by the
ECM and generates the desired target fuel pressure by controlling the fuel pump
motor and regulating fuel flow rate in the low pressure fuel line between the
low and high pressure fuel pumps...
Categories
Operating door locks from
outside the vehicle
Mechanical key
![Hyundai i30. Door locks](images/books/1/hyundai_i30_door_locks_116.png)
Turn the key toward the rear of the
vehicle to unlock and toward the front
of the vehicle to lock.
If you lock/unlock the driver's door
with a key, a driver’s door will
lock/unlock automatically.
read more