Hyundai i-30: Cooling System / Reservoir Tank

Hyundai i30 (PD) 2018-2023 Service Manual / Engine Mechanical System / Cooling System / Reservoir Tank

Repair procedures

Removal and Installation

1.	Drain the engine coolant. (Refer to Cooling System - "Coolant")

Remove the reservoir tank.

(1)	Disconnect the over flow hose (A).

(2)	Disconnect the reservoir tank water hoses (B).

(3)

Remove the reservoir tank (C).

Tightening torque :

7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

3.	Install in the reverse order of removal.

Radiator

Components and components location Components 1. Radiator assembly 2. Mounting insulator 3. Radiator upper mounting bracket 4...

Integrated Thermal Management Module (ITM)

Components and components location Components 1. Herater pipe & hose 2. Intergrated Thermal Management Module (ITM) Repair procedures Removal and Installation Integrated thermal management module (ITM) • Make sure that static electricy and other voltages do not act on the integrated thermal management module (ITM)...

Other information:

Hyundai i30 (PD) 2018-2023 Owner's Manual: Securing a Child Restraint System seat with “Top-tether Anchorage” system

Top-tether anchorages for Child Restraint Systems are located on the rear of the seatbacks. 1. Route the Child Restraint System top-tether strap over the seatback. Placing the top tether strap, please follow the instructions of the Child Restraint System manufacturer...

Hyundai i30 (PD) 2018-2023 Service Manual: Input Speed Sensor

Specifications Specification Item Specification Type Hall effect sensor Output signal High: 11.8 - 16.8 mA Low: 5.9 - 8.4 mA Description and operation Description • Components location : DCT (Dual Clutch Transmission) • Function The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM)...