Hyundai i-30: Engine Mechanical System
Hyundai i30 (PD) 2018-2025 Service Manual / Engine Mechanical System
- Specifications
- Repair procedures
- Troubleshooting
- Special service tools
- Engine and Transaxle Assembly
- Drive Belt System
- Timing System
- Cylinder Head Assembly
- Components and components location
- Cylinder Head Cover
- CVVT & Camshaft
- CVVD Assembly
- Cylinder Head
- Vacuum Pump
- Cylinder Block
- Components and components location
- Fly Wheel
- Water Jacket Seperator
- Rear Oil Seal
- Piston and Connecting Rod
- Crankshaft
- Cylinder Block
- Cooling System
- Coolant
- Cooling Fan
- Radiator
- Reservoir Tank
- Integrated Thermal Management Module (ITM)
- Water pump
- Water Inlet Fitting
- Lubrication System
- Intake and Exhaust System
General Service Information
General Service Information
Protection of the Vehicle
Always be sure to cover fenders, seats, and floor areas prior to beginning work...
Specifications
Specifications
Description
Specification
Limit
General
Type
In-line, DOHC
Number of cylinders
4
Bore
71...
Other information:
Hyundai i30 (PD) 2018-2025 Service Manual: Accelerator Pedal
Repair procedures Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3...
Hyundai i30 (PD) 2018-2025 Owner's Manual: Blind-spot collision warning (BCW) system
[A] : Blind spot area [B] : Closing at high speed The Blind-spot Collision Warning (BCW) system uses radar sensors in the rear bumper to monitor and warn the driver of an approaching vehicle in the driver's blind spot area. The system monitors the rear area of the vehicle and provides information to the driver with an audible alert and an indicator on the outside rearview mirrors...
Categories
- Manuals Home
- 3rd Generation i30 Owners Manual
- 3rd Generation i30 Service Manual
- Battery replacement
- Engine coolant
- Auto door lock/unlock features
- New on site
- Most important about car
Panorama sunroof
If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console.
The ignition switch must be in the ON position before you can open or close the sunroof.
The sunroof can be operated for approximately 30 seconds after the ignition key is removed or turned to the ACC or LOCK(or OFF) position. However, if the front door is opened, the sunroof cannot be operated even within 30 seconds.
Copyright © 2025 www.hi30.net