Hyundai i-30: Engine Control System / EGR Pressure Sensor
Description and operation
The EGR Pressure Sensor is installed on the differential pressure valve and
measures the pressure of the exhaust gas recirculation.

Specifications
Pressure [kPa (kgf/cm², psi)]
|
Output Voltage (V)
|
10 (0.1, 1.5)
|
0.5
|
20 (0.2, 2.9)
|
0.881
|
30 (0.3, 4.4)
|
1.262
|
40 (0.4, 5.8)
|
1.643
|
50 (0.5, 7.3)
|
2.024
|
60 (0.6, 8.7)
|
2.405
|
70 (0.7, 10.2)
|
2.786
|
80 (0.8, 11.6)
|
3.167
|
100 (1.0, 14.5)
|
3.929
|
115 (1.2, 16.7)
|
4.5
|
Schematic diagrams

Harness Connector

Repair procedures
1. |
Connect a diagnostic tool on the Data Link Connector (DLC).
|
2. |
Measure the output voltage of the EGR pressure sensor at idle and IG
ON.
Specification : Refer to "Specification"
|
|
1. |
Turn the ignition switch OFF, and then disconnect the battery negative
(-) terminal.
|
2. |
Disconnect the EGR pressure sensor connector (A).
|
3. |
Remove the installation bolt (B), and then remove the sensor.
Tightening Torque :
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)
|

|
•
|
Install the component with the specified torques.
|
•
|
Note that internal damage may occur when the component is dropped.
If the component has been dropped, inspect before installing.
|
|
1. |
Install in the reverse order of removal.
|
Description and operation
Description
The Boost Pressure Sensor (BPS) is installed on the intercooler assembly and
measures the pressure of the compressed air in turbocharger...
Description and operation
Description
The Engine Coolant Temperature Sensor (ECTS) is located in the cylinder block
and cylinder head, and measures the temperature of the engine coolant...
Other information:
Troubleshooting
Problem Symptoms Table
Before replacing or repairing air conditioning components, first determine if
the malfunction is due to the refrigerant charge, air flow or compressor.
Use the table below to help you find the cause of the problem...
..
Categories

When the High Beam Assist (HBA)
System is not working properly, the
warning message will come on for a
few second. After the message disappears,
the master warning light (
)
will illuminate.
read more