Hyundai i-30: Floor Console / Rear Console Cover
Components and components location
Repair procedures
| •
|
Put on gloves to prevent hand injuries.
|
|
| •
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
| •
|
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
| •
|
Take care not to bend or scratch the trim and panels.
|
|
|
1. |
Remove the floor console assembly.
(Refer to Floor Console - "Floor Console Assembly")
|
|
2. |
Using a screwdriver or remover, remove the rear console cover (A).
|
|
3. |
To install, reverse removal procedure.
|
• |
Make sure the connector is connected properly.
|
|
• |
Replace any damaged clips (or pin-type retainers).
|
|
|
Components and components location
Component Location
[General console]
1. Floor console
assembly
[EPB console]
1...
Components and components location
Component Location
1. Console armrest
Repair procedures
Replacement
•
Put on gloves to prevent hand injuries...
Other information:
■ Type A
■ Type B
For safe operation, carefully read
and follow the instructions in this
manual before use.
(1) Compressor
(2) Sealant bottle
The Tyre Mobility Kit is a temporary
fix to the tyre and we recommend
that the system be inspected by a
HYUNDAI authorised repairer...
Glove box lamp
The glove box lamp comes on when
the glove box is opened.
NOTICE
To prevent unnecessary charging
system drain, close the glove box
securely after using the glove box.
Luggage compartment lamp
The luggage compartment lamp
comes on when the tailgate is
opened...
Categories
To signal a turn, push down on the
lever for a left turn or up for a right
turn in position (A). To signal a lane
change, move the turn signal lever
slightly and hold it in position (B).The
lever will return to the OFF position
when released or when the turn is
completed.
read more
Floor Console Assembly
Console Armrest