Hyundai i-30: Rear Seat / Rear Seat Latch
Components and components location
1. Reat seat
latch [LH]
|
2. Reat seat
latch [RH]
|
Repair procedures
| •
|
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape
around the related parts, to prevent damage.
|
| •
|
Take care not to bend or scratch the trim and panels.
|
|
|
1. |
Remove the rear seat back cover [LH].
(Refer to Rear Seat - "Rear Seat Back Cover")
|
|
2. |
After loosening the mounting bolt, remove the rear seat latch (A).
|
|
3. |
Remove the rear seat latch rod (B) to direction of the arrow.
|
Tightening torque :
16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 lb-ft)
|
|
|
4. |
To install, reverse the removal procedure.
|
| •
|
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape
around the related parts, to prevent damage.
|
| •
|
Take care not to bend or scratch the trim and panels.
|
|
|
1. |
Remove the rear seat back cover [LH].
(Refer to Rear Seat - "Rear Seat Back Cover")
|
|
2. |
After loosening the mounting bolt, remove the rear seat latch (A).
|
|
3. |
Remove the rear seat latch rod (B) to direction of the arrow.
|
Tightening torque :
16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 lb-ft)
|
|
|
4. |
To install, reverse the removal procedure.
|
Repair procedures
Replacement
•
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape
around the related parts, to prevent damage...
Other information:
Components and components location
Component Location
1. Main crash
pad assembly
Repair procedures
Replacement
•
Put on gloves to prevent hand injuries...
You can check the tyre pressure in
the Assist mode on the cluster.
Refer to the "LCD Display
Modes" in chapter 3.
Tyre pressure is displayed after a
few minutes of driving after initial
engine start up.
If tyre pressure is not displayed when
the vehicle is stopped, "Drive to display"
message will appear...
Categories
Seat belt warning
Driver’s seat belt warning
■ Instrument cluster
As a reminder to the driver, the seat
belt warning light will illuminate for
approximately 6 seconds each time
you turn the ignition switch ON
regardless of belt fastening.
read more
Rear Back Armrest
