Hyundai i-30: Restraint / Repair procedures

Hyundai i30 (PD) 2018-2025 Service Manual / Restraint / Repair procedures

Component Replacement After Deployment

•	Before doing any SRS repairs, use the GDS Pro to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs.

When the front airbag(s) deployed after a collision, replace the following items.

–

SRSCM

–	Deployed airbag(s)

–	Front, Rear seat belt pretensioner (s)

–	Anchor pretensioner(s)

–	Front impact sensors

–	SRS wiring harnesses

–	Inspect the clock spring for heat damage. If any damage found, replace the clock spring.

When the side/curtain airbag(s) deployed after a collision, replace the following items.

–

SRSCM

–	Deployed airbag(s)

–	Side impact sensor(s) for the deployed side(s)

–	SRS wiring harnesses

–	Front, Rear seat belt pretensioner(s)

–	Anchor pretensioner(s)

After the vehicle is completely repaired, confirm the SRS airbag system is OK.

–	Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off.

Description and operation

Warning Lamp Activation Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the warning lamp for a LED lamp check...

Components and components location

Components 1. Supplemental Restraint System Control Module (SRSCM) 2. Pressure Side Impact Sensor (P-SIS) 3. Front right Pressure Impact Sensor (FIS) 4...

Other information:

Hyundai i30 (PD) 2018-2025 Service Manual: Rail Pressure Sensor (RPS)

Description and operation Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal...

Hyundai i30 (PD) 2018-2025 Owner's Manual: LED Headlamp Warning Light. Cruise Indicator Light. Cruise SET Indicator Light

LED Headlamp Warning Light This warning light illuminates: When you turn the ignition switch or the Engine Start/Stop button to the ON position. When there is a malfunction with the LED headlamp. In this case, we recommend that you have the vehicle inspected by an a HYUNDAI authorised repairer...