Hyundai i-30: Panorama sunroof / Roller Blind
Repair procedures
1. |
Remove the roof trim.
(Refer to Roof Trim - "Roof Trim Assembly")
|
2. |
Open the roller blind using the panorama sunroof switch.
• |
Leave 10 - 20cm (0.3937 - 0.7874 in) of the roller blind
unopened.
|
|

|
3. |
Remove the roller blind lower support (A) by loosening the mounting
screws.

|
4. |
Using the screwdriver or removal, remove the roll blind (A) by pushing
the lock pin (B) upside of blind.

|
5. |
To install, reverse the removal procedure.
|
Repair procedures
Replacement
1.
Fully open the movable glass using the panorama sunroof switch.
2...
Repair procedures
Removal
•
In order to remove panorama sunroof assembly use tools as follows...
Other information:
Lane Keeping Assist
(LKA) system
Indicator Light
This indicator light illuminates:
[Green] When the system operating
conditions are satisfied.
[White] The system operating conditions
are not satisfied.
[Yellow] When there is a malfunction
with the lane keeping assist
system...
Components and components location
Components
No
Connector A
Connector B
Connector C
1
-
IGN 2 Relay output
Battery signal
2
SSB Switch 1 input
C CAN (Low)
-
3
Driver door antenna switch input
C CAN (High)
Immoblizer antenna power
4
-
B CAN (High)
Driver out side handle antenna power
5
-
B CAN (Low)
Assist out side handle antenna power
6
-
SSB Illumination (orange)
Bumper antenna power
7
RPM Input
-
Interior antenna 1 power
8
Start signal feedback input
SSB Illumination (+) output
Interior antenna 2 power
9
clutch switch input
ESCL enable output
Interior antenna 3 power
10
-
Battery power
-
11
Starter relay output
IGN 1 Relay output
-
12
Power 1
ESCL COM
-
13
SSB Switch 2 input
EMS COM
ESCL (-) output
14
Assist door antenna switch input
-
Immoblizer antenna ground
15
-
SSB Illumination (-) output
Driver out side handle antenna ground
16
Clutch switch input
SSB LED Output
Assist out side handle antenna ground
17
ESCL unlock swtich input
SSB LED IGN Output
Bumper antenna ground
18
Wheel speed sensor input
External buzzer
Interior antenna 1 ground
19
ACC Input
-
Interior antenna 2 ground
20
IGN 1
ESCL (+) output
Interior antenna 3 ground
21
Brake switch input
-
22
ACC Relay input
GND Power 2
Schematic diagrams
Circuit Diagram
Repair procedures
Removal
Smart Key Unit
1...
Categories

1. Driver’s front air bag
2. Passenger’s front air bag
3. Side air bag*
4. Curtain air bag*
5. Knee air bag*
6. Front passenger air bag ON/OFF
switch
read more