Hyundai i-30: Tail Gate / Tail Gate Latch
Components and components location

1. Tail Gate
latch assembly
|
Repair procedures
•
|
Put on gloves to prevent hand injuries.
|
|
•
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
•
|
Take care not to scratch the body surface.
|
|
1. |
Remove the tail gate trim.
(Refer to Tail Gate - "Liftgate Trim")
|
2. |
Disconnect the tail gate latch connector (A).

|
3. |
After loosening the mounting bolts, then remove the tail gate latch
assembly (A).
Tightening torque :
6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)
|

|
4. |
To install, reverse removal procedure.
• |
Make sure the tail gate locks / unlocks and opens /
closes properly.
|
• |
Adjust the tail gate alignment.
|
• |
Make sure the connectors are connected in properly.
|
|
|
Components and components location
Component Location
1. Tail Gate
trim
Repair procedures
Replacement
[Tail Gate lower trim]
•
Put on gloves to prevent hand injuries...
Repair procedures
Replacement
•
Take care to not let the tail gate fall on you as the lifts
are removed...
Other information:
Master Warning Light
This indicator light illuminates:
• When there is a malfunction in the
below systems.
- Low washer fluid (if equipped)
- Exterior lamp malfunction
(if equipped)
- HBA (High Beam Assist) malfunction
(if equipped)
- BCW (Blind-Spot Collision
Warning) malfunction
(if equipped)
- FCA (Forward Collision-
Avoidance Assist) malfunction
(if equipped)
- ISLW (Intelligent Speed Limit
Warning) malfunction
(if equipped)
- SCC (Smart Cruise Control) malfunction
(if equipped)
- Tyre Pressure Monitoring System
(TPMS)
To identify the details of the warning,
look at the LCD display...
WARNING
A vehicle can slip or roll off of a
jack causing serious injury or
death to you or those nearby.
Take the following safety precautions:
Do not get under a vehicle
that is supported by a jack.
NEVER attempt to change a
tyre in the lane of traffic...
Categories
If your vehicle is equipped with a
sunroof, you can slide or tilt your
sunroof with the sunroof control lever
located on the overhead console.

The ignition switch must be in the ON
position before you can open or
close the sunroof.
The sunroof can be operated for
approximately 30 seconds after the
ignition key is removed or turned to
the ACC or LOCK(or OFF) position.
However, if the front door is opened,
the sunroof cannot be operated even
within 30 seconds.
read more