Hyundai i-30: Seat belts / Care of seat belts

Hyundai i30 (PD) 2018-2025 Owner's Manual / Safety system of your vehicle / Seat belts / Care of seat belts

Seat belt systems should never be disassembled or modified. In addition, care should be taken to assure that seat belts and belt hardware are not damaged by seat hinges, doors or other abuse.

Periodic inspection

All seat belts should be inspected periodically for wear or damage of any kind. Any damaged parts should be replaced as soon as possible.

Keep belts clean and dry

Seat belts should be kept clean and dry. If belts become dirty, they can be cleaned by using a mild soap solution and warm water. Bleach, dye, strong detergents or abrasives should not be used because they may damage and weaken the fabric.

When to replace seat belts

The entire seat belt assembly or assemblies should be replaced if the vehicle has been involved in an accident. This should be done even if no damage is visible.We recommend that you consult a HYUNDAI authorised repairer.

Additional seat belt safety precautions

Seat belt use during pregnancy The seat belt should always be used during pregnancy. The best way to protect your unborn child is to protect yourself by always wearing the seat belt...

Child restraint system (CRS)

Our recommendation: Children always in the rear WARNING Always properly restrain children in the vehicle. Children of all ages are safer when riding in the rear seats...

Other information:

Hyundai i30 (PD) 2018-2025 Service Manual: Brake Booster

Components and components location Components [LHD] 1. Reservoir cap 2. Reservoir 3. Brake booster 4. Master cylinder 5. Push rod [RHD] 1. Reservoir cap 2...

Hyundai i30 (PD) 2018-2025 Service Manual: Heater & A/C Control Unit (DATC)

Components and components location Components Connector [A] Pin NO Function Pin NO Function 1 Battery (+) 21 IGN2 2 ISG B+ 22 IGN1 3 ILL+ (TAIL) 23 Blower motor (+) 4 Sensor REF (+5V) 24 Photo sensor_LH 5 Mode actuator feedback 25 Photo sensor_RH 6 Temperature actuator feedback 26 - 7 Intake actuator feedback 27 - 8 EVAP Sensor (+) 28 PTC Relay 3 9 AMB Sensor (+) 29 PTC Relay 2 10 Mode actuator (Vent) 30 PTC on signal 11 Mode actuator (Defrost) 31 Detent OUT (-) 12 Temperature actuator (Cool) 32 - 13 Temperature actuator (Warm) 33 C_CAN High 14 Intake actuator (Fresh Air) 34 C_CAN Low 15 Intake actuator (Recirculated Air) 35 Power mosfet (Drain feed back) 16 HTD (Rear defog indicator) 36 Power mosfet (Gate) 17 Rear defog switch 37 ECV + 18 Clean signal 38 ECV- (Ground) 19 Ionizer diagnosis 39 Sensor ground 20 ILL- (RHEO) 40 Ground Connector [B] Pin NO Function Pin NO Function 1 Passenger's temperature control actuator (Feedback) 9 - 2 Passenger's temperature control actuator (Cool) 10 Duct sensor (+)_Vent 3 Passenger's temperature control actuator (Warm) 11 Duct sensor (-)_Floor 4 Auto defogging (Feedback) 12 Auto defogging sensor signal 5 Auto defogging (Open) 13 - 6 Auto defogging (Off) 14 - 7 - 15 - 8 - 16 Ground Repair procedures Self Diagnosis 1...