Hyundai i-30: Interior Trim / Door Scuff Trim
Components and components location

1. Front door
scuff trim
|
2. Rear door
scuff trim
|
Repair procedures
•
|
Put on gloves to prevent hand injuries.
|
|
•
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
•
|
When removing the interior trim pieces, use a plastic panel
removal tool not to damage the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Using a screwdriver or remover, remove the front door scuff trim (A).
[Front]

|
2. |
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
|
3. |
After loosening the mounting screws, remove the rear door scuff trim
(A).
[Rear]

|
4. |
To install, reverse removal procedure.
• |
Replace any damaged clips (or pin-type retainers).
|
|
|
Components
1. Cowl side
trim
2. Center pillar lower trim
3. Front pillar trim
4. Door front scuff trim
5...
Components and components location
Component
1. Front door
step trim
2. Rear door
step trim
Repair procedures
Replacement
•
Put on gloves to prevent hand injuries...
Other information:
After a frontal or side air bag inflates,
it will deflate very quickly. Air bag
inflation will not prevent the driver
from seeing out of the windscreen or
being able to steer. Curtain air bags
may remain partially inflated for
some time after they deploy...
Description and operation
Description
Introduction of Quick Brake Warning System (ESS)
In case of quick brake by driver, the brake lamp or turn signal is blinked to
warn against the vehicle at rear.
1.
Basic function (Blinking the brake lamp/emergency lamp)
–
Operation condition : In case of quick brake or operation of
ABS above in a certain speed
–
Releasing condition : In case of stopping the quick brake or
releasing the ABS operation
2...
Categories

To signal a turn, push down on the
lever for a left turn or up for a right
turn in position (A). To signal a lane
change, move the turn signal lever
slightly and hold it in position (B).The
lever will return to the OFF position
when released or when the turn is
completed.
read more