Hyundai i-30: Front Door / Front Door Latch
Components and components location

Repair procedures
1. |
Remove the plug hole (B).
|
2. |
After loosening the mounting bolt, remove the front door outside handle
cover (A).
Tightening torque :
6.5 - 8.8 N.m (0.7 - 0.9 kgf.m, 5.1 - 6.5 lb-ft)
|

|
3. |
Remove the front door outside handle (A) by sliding it forward.

|
4. |
Disconnect the front door outside handle connector (A) by pushing the
locking pin.

|
5. |
To install, reverse removal procedure.
• |
Make sure the connector is connected properly.
|
• |
Make sure the door locks / unlocks and opens / closes
properly.
|
• |
Be sure to install the outside handle pad (A) between
the outside handle and the door panel.

|
|
|
Components and components location
Component Location
1. Front door
outside handle
Repair procedures
Replacement
1...
Components and components location
Component Location
1. Front door
latch
Repair procedures
Replacement
1...
Other information:
Components and components location
Component Location
1. Front door
scuff trim
2. Rear door
scuff trim
Repair procedures
Replacement
•
Put on gloves to prevent hand injuries...
Repair procedures
Hub nut tightening sequence
1.
Tighten the hub nuts as follows.
Tightening torque :
107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)
•
When using an impact gun, final tightening torque should
be checked using a torque wrench...
Categories

1. Driver’s front air bag
2. Passenger’s front air bag
3. Side air bag*
4. Curtain air bag*
5. Knee air bag*
6. Front passenger air bag ON/OFF
switch
read more