Hyundai i-30: Engine Control System / Fuel Pressure Control Valve (FPCV)

Hyundai i30 (PD) 2018-2025 Service Manual / Engine Control / Fuel System / Engine Control System / Fuel Pressure Control Valve (FPCV)

Description and operation
Description
Fuel Pressure Control Valve (FPCV) is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on various engine condition.

Specifications
Specification
Item
Specification
Coil Resistance (Ω)
0.52 - 0.58 [20°C (68°F)]

Schematic diagrams
Circuit Diagram

Harness Connector

Repair procedures
Inspection
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the fuel pressure regulator valve connector.
3.
Measure resistance between the fuel pressure regulator valve terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification : Refer to "Specification"

    CVVD Actuator

    Description and operation Description CVVD(Continuous Variable Valve Duration) System is a device to control the optimum open and close timing according to the driving mode by changing the valve opening section...

    ISG (Idle Stop & Go) System

    ..

    Other information:

    Hyundai i30 (PD) 2018-2025 Owner's Manual: Detecting pedestrians


    The sensor may be limited when: The pedestrian is not fully detected by the camera recognition system, for example, if the pedestrian is leaning over or is not fully walking upright The pedestrian is moving very quickly or appears abruptly in the camera detection area The pedestrian is wearing clothing that easily blends into the background, making it difficult to be detected by the camera recognition system The outside lighting is too bright (e...

    Hyundai i30 (PD) 2018-2025 Owner's Manual: Limitations of the system


    The Forward Collision avoidance assist (FCA) system system is designed to monitor the vehicle ahead or a pedestrian in the roadway through radar signals and camera recognition to warn the driver that a collision is imminent, and if necessary, apply emergency braking...

    Categories

    Warning light and message

    Hyundai i30. Warning light and message

    When the High Beam Assist (HBA) System is not working properly, the warning message will come on for a few second. After the message disappears, the master warning light (Hyundai i30. Warning light and message) will illuminate.

    read more


     
    Copyright © 2025 www.hi30.net