Hyundai i-30: Engine Control / Fuel System / ISG (Idle Stop & Go) System

Hyundai i30 (PD) 2018-2025 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System

Fuel Pressure Control Valve (FPCV)

Description and operation Description Fuel Pressure Control Valve (FPCV) is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on various engine condition...

Description and operation

Description Idle Stop & Go (ISG) system switches off the ignition when vehicle is stopped, and then restarts the ignition and starts the vehicle when accelerator is pushed...

Other information:

Hyundai i30 (PD) 2018-2025 Service Manual: Troubleshooting


Troubleshooting Symptom Passible Cause Remedy (Refer to page) Water leaks from panorama sunroof Deteriorated roof lid weatherstrip Replace Excessive roof lid-to-body clearance and improperly fitted weatherstrip Adjust Wind noise around Panorama sunroof Loose or deformed deflector, gaps in body work Retighten adjust or replace Noise created by moving panorama sunroof lid Foreign particles lodged in guide rail Check drive cable and guide rails for foreign particles Loose guide rails and lid Retighten Motor runs but sunroof does not move or moves only partially Foreign particles lodged in guide rail Adjust or replace Incorrect engagement of motor pinion with drive cable Decrease in motor's clutch slipping force Increased sunroof sliding resistance or interference of sunroof with drive cables, weatherstrip, etc...

Hyundai i30 (PD) 2018-2025 Owner's Manual: Securing a Child Restraint System seat with “Top-tether Anchorage” system


Top-tether anchorages for Child Restraint Systems are located on the rear of the seatbacks. 1. Route the Child Restraint System top-tether strap over the seatback. Placing the top tether strap, please follow the instructions of the Child Restraint System manufacturer...

Categories

Turn signals and lane change signals

Hyundai i30. signals

To signal a turn, push down on the lever for a left turn or up for a right turn in position (A). To signal a lane change, move the turn signal lever slightly and hold it in position (B).The lever will return to the OFF position when released or when the turn is completed.

read more


 
Copyright © 2025 www.hi30.net