Hyundai i-30: Lighting System / Hazard Lamp Switch
Repair procedures
•
|
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
•
|
When removing the interior trim pieces, use a plastic panel
removal tool not to damage the surface.
|
•
|
Be careful to store and handle the trim when removing/installing
because lubricant and oil can leave a stain on the trim.
|
•
|
Be careful not to scratch the door trim and other parts.
|
|
1. |
Disconnct the negative (-) battery terminal.
|
2. |
Disconnect the crash pad Garnish.
(Refer to Body - "Crash Pad Garnish Assembly[RH]")
|
3. |
Remove the hazard lamp switch after disengaging the retaining clips.

|
1. |
Install the hazard lamp switch.
|
2. |
Install the hazard lamp switch assembly.
|
3. |
Connect the negative (-) battery terminal.
|
Repair procedures
Inspection
1.
Remove the overhead console lamp assembly and check for continuity between
terminals...
Components and components location
Components
Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal...
Other information:
Removal
[Gasoline 1.0 T-GDI]
1.
Turn OFF ignition switch and disconnect the negative (-) battery cable.
2.
Remove the clutch master cylinder.
1)
Separate the push rod (A)...
Driver’s and passenger’s front
air bags
Your vehicle is equipped with a
Supplemental Restraint System
(SRS) and lap/shoulder belts at both
the driver and passenger seating
positions.
The SRS consists of air bags which
are located in the centre of the steering
wheel, in the driver’s side lower
crash pad below the steering wheel,
and the passenger's side front panel
pad above the glove box...
Categories

To signal a turn, push down on the
lever for a left turn or up for a right
turn in position (A). To signal a lane
change, move the turn signal lever
slightly and hold it in position (B).The
lever will return to the OFF position
when released or when the turn is
completed.
read more