Hyundai i-30: Body Electrical System / Smart Key System
Hyundai i30 (PD) 2018-2025 Service Manual / Body Electrical System / Smart Key System
- Specifications
- Components and components location
- Description and operation
- Smart Key
- Smart Key Unit
- Smart Key Diagnostic
Emergency Call (eCall) Antenna
Schematic diagrams
Components
Russia
Europe
Repair procedures
Removal
Roof Antenna
1.
Disconnect the negative (-) battery terminal...
Specifications
Specifications
Smart Key Unit
Items
Specification
Rated voltage
DC 12V
Operating voltage
DC 9 - 16V
Operating temperature
-22°F to 167°F (-30°C to 75°C)
Load
Max...
Other information:
Hyundai i30 (PD) 2018-2025 Service Manual: Rail Pressure Sensor (RPS)
Description and operation Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal...
Hyundai i30 (PD) 2018-2025 Service Manual: Differential Pressure Valve (DPV)
Description and operation Description Differential pressure valve (DPV) is control the pressure difference of EGR inlet and outlet. Specifications Specification [Motor] Item Specification Coil Resistance (Ω) 2...
Categories
- Manuals Home
- 3rd Generation i30 Owners Manual
- 3rd Generation i30 Service Manual
- Front windscreen wiper service position
- Brake/clutch fluid
- FCA sensor
- New on site
- Most important about car
Panorama sunroof
If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console.
The ignition switch must be in the ON position before you can open or close the sunroof.
The sunroof can be operated for approximately 30 seconds after the ignition key is removed or turned to the ACC or LOCK(or OFF) position. However, if the front door is opened, the sunroof cannot be operated even within 30 seconds.
Copyright © 2025 www.hi30.net