Hyundai i-30: Engine Mechanical System / Cylinder Block
Hyundai i30 (PD) 2018-2025 Service Manual / Engine Mechanical System / Cylinder Block
- Components and components location
- Fly Wheel
- Water Jacket Seperator
- Rear Oil Seal
- Piston and Connecting Rod
- Crankshaft
- Cylinder Block
Vacuum Pump
Repair procedures
Removal And Installation
1.
Disconnect the battery negative terminal.
2.
Remove the engine cover...
Components and components location
Components
1. Piston
ring
2. Piston
3. Piston pin
4. Connecting rod
5. Connecting rod upper bearing
6...
Other information:
Hyundai i30 (PD) 2018-2025 Service Manual: Crankshaft
Components and components location Components 1. Thrust bearing 2. Upper main bearing 3. Crankshaft 4. Lower main bearing 5. Main bearing cap Repair procedures Disassembly • Use fender covers to avoid damaging painted surfaces...
Hyundai i30 (PD) 2018-2025 Service Manual: Accelerator Position Sensor (APS)
Description and operation Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line...
Categories
- Manuals Home
- 3rd Generation i30 Owners Manual
- 3rd Generation i30 Service Manual
- Front windscreen wiper service position
- Drive mode integrated control system
- Cruise control
- New on site
- Most important about car
Turn signals and lane change signals
To signal a turn, push down on the lever for a left turn or up for a right turn in position (A). To signal a lane change, move the turn signal lever slightly and hold it in position (B).The lever will return to the OFF position when released or when the turn is completed.
Copyright © 2025 www.hi30.net